Wow, dude that thing looks awesome! Did u coat ur headers?
So, did u run into any issues with the install?
i will eventually coat the headers, thats the rattle can VHT but it works awesome!! at the time of the build i didnt wanna put out anouther $350 bucks for the headers and turbo hot side coating.
i had ZERO issuues with the install!! nothing!! its 3 simple Vbands and done! and i only have about 2700 in the kit and turbo!
Man, that's nasty. Im selling my vortech kit to fund my Turbo build. Do you know anyone else running this kit? Im looking to try and hit 700rwhp with what im running for an engine now.
Forged 5.0 stroked
Ported pi heads
mhs stg 1 cams
Mhs stage 2 valve springs
Victor efi lower
6061 upper
75mm tbody
i only know of a few people over the internet with the kit and all have had great results, i gaurentee it will make 700whp, a local buddy runs a 331, my my same turbo t76 Ptrim, car has went in the mid 9's at a best mph of 146!
car is a 331, but very close to my setup, same turbo, c4, gears and tires. he runs 20lbs on boost with a meth kit
hey i was reading about some guys having issues with leaks at the vbands, have u ran into any of this?i will eventually coat the headers, thats the rattle can VHT but it works awesome!! at the time of the build i didnt wanna put out anouther $350 bucks for the headers and turbo hot side coating.
i had ZERO issuues with the install!! nothing!! its 3 simple Vbands and done! and i only have about 2700 in the kit and turbo!
ill bet it could make over 700whp, on 13lbs i went 10.53@131 spinning with not a great 60' 1.66. im running the master power 76
BTW. it made 525rwhp on 10lbs, shutting the pull down at 5600 rpms becasue it was blowing the spark out. and pig rich!
hey i was reading about some guys having issues with leaks at the vbands, have u ran into any of this?
Just so you know.....I reported this post for pornography.....
yea they do, cause there just cheap vbands. good ones are about 30 bucks each i just havent got them yet. they only seep a little, no loud ticks
Thank you!
When u say "vbands", are u talking about just the clamps or both flanges and clamp as a whole. I was reading that guys are buying 2.5 obx gaskets, trimming the bolt holes off, and putting them between the flanges making a good tight seal. What unthink about that? Btw, I sold my s trim today! I'm calling poweraddersolutions Monday to order my kit!!!!!!!!!
What kemeber did u use?just the clamps! and yes ive been planning to do that for a while! lol
Hey
What kemeber did u use?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?