ONE MORE 5 LUG QUESTION

noahsark

New Member
Mar 31, 2006
14
0
0
:shrug:

http://cgi.ebay.com/ebaymotors/1990-...cmdZVi ewItem

This car has the FRPP 5 lug conversion kit in it and he still has the bullit wheels on it. I thought the FRPP kit had the larger dustcaps and the center caps of the Bullits would not fit? I am going to use these exact wheels only I am going to do 18x9 all the way around with deep dish in the rear.

Can I get away with the FRPP kit with these wheels? I am going to run 275's in the back and 255's in the front. If that kit will work, where is the best place to get the kit?

Sorry to beat a dead horse, but I am trying to get the 5 lug bullits on my car the easiest way I can.

Thanks
 
Here are some pics

Sorry,

Here are some pics. The FRPP kit as I understand it does not have the SN-95 hub, thats why I am curious if they will fit.
 

Attachments

  • 18 bullit.webp
    18 bullit.webp
    24.3 KB · Views: 236
  • black bullit 18.webp
    black bullit 18.webp
    25.2 KB · Views: 182
If I remember right, there are a couple of "FRPP" kits--one with the rear axles/drums and different front rotors and the good one which is the 2300-K kit which is 5 lug with SN95 setup.

There is a great price difference, too. The top of the line M-2300-K kit is about 1900 IIRC and the other one is a lot cheaper.

I have seen people use bullitts with just the rotor setup and good use of a dremel.
 
Those wheels will go right on however the center cap of the wheel doesn't go on because of the height of the hub of the Lincoln/SVO rotor. There are a few ways around it one being longer studs and spacers (if u go this route you have to constantly check your lugs for tightness, just to be safe). I have also seen poeple grind them down. If you are wanting the easiest way with out going all wheel disc brakes, imo, just get the FRPP rear axles or get them from a Ranger and swap out the front spindles off a 94-95. Its an easy job. here are some links http://www.stangnet.com/tech/lug.html http://mjbobbitt.home.comcast.net/mustang/5lug.html
 
Worst Case

If I grind the dust caps down with a dremel or something, whats the worst that can happen? Anybody done this with some success? This is my last comment on this topic, I promise.:flag:
 
noahsark said:
If I grind the dust caps down with a dremel or something, whats the worst that can happen? Anybody done this with some success? This is my last comment on this topic, I promise.:flag:


Well if you grind down the snout of the rotor the best case is that it will work and the worst case is you overheat the metal and make it brittle causing your wheel to fall off while you drive.


I'm against any modifications to the front brakes in order to fit wheels. If you can't do it right don't do it at all.
 
Mustang5L5 said:
Well if you grind down the snout of the rotor the best case is that it will work and the worst case is you overheat the metal and make it brittle causing your wheel to fall off while you drive.


I'm against any modifications to the front brakes in order to fit wheels. If you can't do it right don't do it at all.

I will 2nd that!!!
 
Hey Mustang5L5...thanks for the reply, and I must ask................

I have seen you on here many of times, but where is the girl in your avatar from?? Her "friends" are enourmous.:lol: