opinions on this magical knock/tick sound...

CDQICKGT

New Member

Jan 25, 2006

229

0

0

fort hood, tx

Jul 28, 2010

#1

• Jul 28, 2010

• #1

ive had this awesome noise for a little while now. its only at idle though and sounds like its right under the valve covers. I was thinking either lifter(s) or rocker arms. it has a b cam and 1.6 svo rockers that were on it when i bought it. Let me know what you guys think.

YouTube - CIMG6321
YouTube - CIMG6320

 

CDQICKGT

New Member

Jan 25, 2006

229

0

0

fort hood, tx

Jul 29, 2010

#2

• Jul 29, 2010

• #2

Hmmmm...ttt

 

CDQICKGT

New Member

Jan 25, 2006

229

0

0

fort hood, tx

Jul 29, 2010

#3

• Jul 29, 2010

• #3

Does my thread just suck, or is there something wrong with the vids?

 

BlackGT89

Member

Dec 16, 2002

774

8

18

Huntsville, AL

Jul 29, 2010

#4

• Jul 29, 2010

• #4

Nothing wrong with the vids, but it would only be a guess. The video from the top just sounds like rocker arm noise to me. From what I hear some roller rockers are just louder than others. It would certainly be worth taking the valve cover off and having a look especially if it's been a while. As far as the noise on the bottom, the first thing I think of is rod bearings that have a few thousand miles on them. How man miles on the engine ? How is your oil pressure ?

 

CDQICKGT

New Member

Jan 25, 2006

229

0

0

fort hood, tx

Jul 29, 2010

#5

• Jul 29, 2010

• #5

125k on the bottom side. Oil pressure is fine. Both videos show same noise, it echos to the bottom side. I was just trying to show it in many ways as possible.

 

Michael Yount

Mustang Master

Apr 10, 2002

9,039

6

79

Charlotte, NC

Jul 31, 2010

#6

• Jul 31, 2010

• #6

Many times when mods like yours are made, people simply put the stock pushrod back in and let it go at that. Fact is, pushrod length IS the adjustable factor with pedestal mount rockers. So, when head gasket, heads, rockers, cam, lifters, valves are changed - or the heads are cut, block is cut, valve job is done - pushrod length should be MEASURED with an adjustable pushrod length checker. It is VERY common that slightly longer than stock pushrods are needed to put everything back like it should be with proper lifter preload. When this isn't done - a bit of noise is usually the symptom.

No way of knowing if that's your issue or not unless you pull the covers and go through the drill of checking pushrod length.

 

CDQICKGT

New Member

Jan 25, 2006

229

0

0

fort hood, tx

Jul 31, 2010

#7

• Jul 31, 2010

• #7

Would a bad balancer cause that knock? Mine wobbles a bit and I have a vibration around 3-4k.

 

BlackGT89

Member

Dec 16, 2002

774

8

18

Huntsville, AL

Jul 31, 2010

#8

• Jul 31, 2010

• #8

The first thing I noticed when my balancer went bad was a vibration, not necessarily a noise. You can almost see the balancer wobble when it hits the RPM zone that agitates it. And when the engine is off you might even be able to see where the rubber is separating.