I found a company that makes reasonably priced accessory stud kits. I have purchased a valve cover stud kit. After getting it, I contacted them and gave them the specs for an AOD pan bolt and now they make AOD pan studs.
I contacted them and asked about a lower Intake stud kit. I figured it would make keeping the gasket straight when lowering the intake over the top of it. I gave them the bolt size and they have 2 options to make, what do you guys think is best?
A standard type stud where the threads are seperated by a soild piece, or a set screw type where it is all thread with an Allen head at the top for easy install?
Here is a pic of the set screw type.
View attachment 462359
So, what do you guys think. Good idea or waste of time? He will put these into production for purchase and the cost for a set of 12 is 19.25 shipped.
I contacted them and asked about a lower Intake stud kit. I figured it would make keeping the gasket straight when lowering the intake over the top of it. I gave them the bolt size and they have 2 options to make, what do you guys think is best?
A standard type stud where the threads are seperated by a soild piece, or a set screw type where it is all thread with an Allen head at the top for easy install?
Here is a pic of the set screw type.
View attachment 462359
So, what do you guys think. Good idea or waste of time? He will put these into production for purchase and the cost for a set of 12 is 19.25 shipped.