Crzyhrse said:In most cases, but not all, if it does'nt specifically say Mach 1 for a part listing, then the GT part will fit on the Mach. I have yet to buy a part where you picked the '99-'01 Cobra part as the part you need for the Mach if your looking for it. I just bought some different valve covers, and those were listed under "Cobra" valve covers. If in doubt, just call the company.
1meanmach said:if headers say they will fit 99-04 cobras will they fit mach1? what about x-pipe would you but cobra or gt?
Not true. All midpipes are the same wether it being a Mach1, GT, or Cobra. You don't want headers for a GT being it comes with a SOHC engine.You want the headers for a Cobra being it has a DOHC engine.Crzyhrse said:Buy the GT for the X-pipe. As far as headers I looked up a website and the Mach fell under the GT also for BBK and Bassani, so the other brands should follow suit also.
scottmach said:Not true. All midpipes are the same wether it being a Mach1, GT, or Cobra. You don't want headers for a GT being it comes with a SOHC engine.You want the headers for a Cobra being it has a DOHC engine.
Once again, you cannot use the headers if there for a GT. SOHC. The headers for the 03-04 Cobra are the same as our Mach1's. DOHC. Just be careful.Crzyhrse said:At the ninosport website, the headers for BBK and Bassani is listed as 1996-04 Mustang GT, Mach 1. The listing for Cobra stuff is in a totally different category. I think I'll go with the category that actually says Mach 1 in it.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?