Hey everyone!
Its been a while since i've posted, but im having a problem that I need someone's help with.
Here's my situation:
I've recently reworked a 302. It is .030 over, with flat top high compression pistons. The heads are ported and polished w/ a 1.94 intake and 1.6 exhaust I've got a larger pan with a high flow oil pump. On top I got edlebrock street/strip performance intake with a 600 cfm holly. on the bottom, of course a set of long tube headers. Right now, I am using a Ford Duraspark II system from early 80s 5.0L. The Engine is in with the only the headers.
I am a bit excited to hear her roar!
Here's my problem:
When turning it over, I can get cylinders to fire in the Key Start Position and it almost wants to start. Once I take it from Key Start to Key Run Position, the engine quickly dies. Sounds like to me that the spark stops.
I have re-wired the ignition system to a push button start direct to the starter and ignition control module. I have taken 12 volt from a wire that was 12 volt key on to go to the ignition control module for other wire.
I have tried a new control module with same problem.
ANY IDEAS???? please help, i want drive her!
Its been a while since i've posted, but im having a problem that I need someone's help with.
Here's my situation:
I've recently reworked a 302. It is .030 over, with flat top high compression pistons. The heads are ported and polished w/ a 1.94 intake and 1.6 exhaust I've got a larger pan with a high flow oil pump. On top I got edlebrock street/strip performance intake with a 600 cfm holly. on the bottom, of course a set of long tube headers. Right now, I am using a Ford Duraspark II system from early 80s 5.0L. The Engine is in with the only the headers.
I am a bit excited to hear her roar!
Here's my problem:
When turning it over, I can get cylinders to fire in the Key Start Position and it almost wants to start. Once I take it from Key Start to Key Run Position, the engine quickly dies. Sounds like to me that the spark stops.
I have re-wired the ignition system to a push button start direct to the starter and ignition control module. I have taken 12 volt from a wire that was 12 volt key on to go to the ignition control module for other wire.
I have tried a new control module with same problem.
ANY IDEAS???? please help, i want drive her!