So we pi swapped a family members 98 gt. Installed pypes long tube headers as well. I cannot get the dip stick tube to go into the block fully therefore the dip stick itself will not go and feels as if its in a bind. there are no kinks in the tube itself, we only cut off the flange that holds it to the heads. I THINK we used the swap tube that came with the head swap kit (frpp) as the orig 98 tube was NO WHERE close.
What have you guys done to make this work or what am I missing. Obviously I'm very space limited down there but I know there is a way to make this work. This is the last piece of the puzzle so I can get this turn out of my garage.
What have you guys done to make this work or what am I missing. Obviously I'm very space limited down there but I know there is a way to make this work. This is the last piece of the puzzle so I can get this turn out of my garage.