Pinion Seal

Aryan15

Member
Sep 22, 2003
236
0
17
CA
Im doing a ring/pinion gear swap and replacing the bearings and seals. Right now im trying to get the pinion seal out to get the outer pinion bearing and race out. I tried prying on the seal but it wont budge. I cant get a small flat tipped screwdriver between the housing and the flange on the seal. I Tried driving the outer pinion bearing out but it moved about a quarter of an inch and stopped on the seal. Any hints on how to get this thing out?
 
With a rubber mallet or brass punch, hammer the pinion gear. It will need to go in about ½” to ¾” to get past the pinion flange. The flange will fall off and a few more whacks should free up the pinion. Remove it from the housing and set aside.

fig14.webp


copied from http://www.superstallions.com/tech/drive/gears/gears.html
 

Attachments

  • fig14.webp
    fig14.webp
    446.8 KB · Views: 180