Pioneer balancer install tomorrow!!

S

somersdp

New Member

Nov 16, 2003

191

1

0

WPB,Florida

Dec 22, 2003

#1

• Dec 22, 2003

• #1

Just wondering if there is anything I need to do to install this balancer in the morning. I know that the balancer needs to lose the 15/16" retaining nut and be pulled with a puller. Do I grease the crank before instalation or anything? should I just pull off the old one and put the new one on and replace the pulley? Just checking if there are any tricks or anything I am forgetting? PLease let me know. Thanks guys. Should the pioneer balancer dampen better at high rpm's than the stock harmonic balancer?

 

tvmango

New Member

Oct 27, 2003

667

0

0

bradenton florida

Dec 22, 2003

#2

• Dec 22, 2003

• #2

I know there isn't many tricks,, i would put a bit of oil on the inside and outside so you don't damage the seal lip.. I don't know about your other ????

 

S

somersdp

New Member

Nov 16, 2003

191

1

0

WPB,Florida

Dec 22, 2003

#3

• Dec 22, 2003

• #3

Thanks man, I know it is pretty cut and dry, but I have to cover my bases ya know. PLus I was wondering If i grease the crank or put oil on it. Anyone else can give me suggestions if you have something else maybe you have run into when replacing one!!

 

Pyro85GT

Fire? What fire?

Aug 25, 2000

4,304

0

0

San Antonio, TX

Dec 23, 2003

#4

• Dec 23, 2003

• #4

when we replaced mine we used some grease but some antiseize would probably work also

 

S

somersdp

New Member

Nov 16, 2003

191

1

0

WPB,Florida

Dec 23, 2003

#5

• Dec 23, 2003

• #5

I think I will try some antisieze on the actual crank shaft and then put some lithium grease inbetween the seal and the balancer......is that right? Easy job , I just wanted to check with you guys first ya know.