Plugging th PCV installing a breather cap

[95strokerPSU]

I've been getting some oil in my intake and I'm almost positive it's coming from the PCV (well hopefully anyway). My question is, can I plug off the PCV and just put a breather cap on the oil fill neck? Will this allow for enough ventilation?

Thanks
Dave

 

[S/CBlack95GT]

Dont plug the PCV in the back of the intake, plug the nipple on the filler neck and slip the hose back over it. You can just use a piece of electric tape to put over the nipple then slip the hose back on. After that you can toss the breather in place of the oil cap.

 

[95strokerPSU]

So I can't plug the PCV?

And using the breather cap in addition to the PCV will help vent more, stopping the oil from coming up?

Thanks

 

[S/CBlack95GT]

I wouldnt plug the PCV in the back of the intake. There is no reason and plus leaving it open will only help to vent more.

 

[95strokerPSU]

How about just plugging it with a breather for a couple miles, just to see if I'm still getting oil in the intake? Cause then if I still am the oil is coming from something else; i.e bad valve seat, bad piston rings

 

[S/CBlack95GT]

Yea you could try that. I get some oil in mine from the PVC, but it is not a lot so I dont worry about it.

 

[95strokerPSU]

thanks for you help.