- Nov 10, 2009
- 312
- 0
- 0
i've been doing some reading on this site and spent a lot time going through MMs site along with a couple of others and here's what i've come up with...
1) MMs XL full length sub-frames................$150
2) front coil over kit with springs................$354
3) Tokico D spec shocks/struts..................$560
4) MMs k-member....................................$90
5) MMs rear lower control arms..................$250
6) MMs Panhard Bar.................................$330
7) MMs Heavy Duty Torque Arm.................$650
8) MMs caster camber plates.....................$200
a couple of things i'm not sure of, there is a huge difference in the way a MM k-member looks vs a k-member from other places. also a huge difference in price. i've also read that tubular a-arms need to go along with a tubular k-member. MMs site doesn't mention that but there piece doesn't look as elaborate as the QA1 (and others) piece. also, i'm not sure what springs i'd need to run in the rear.
i don't know that i'll end up going this elaborate but from what i've read up to this point it should be a pretty "sticky" setup........right?
what did i miss?
1) MMs XL full length sub-frames................$150
2) front coil over kit with springs................$354
3) Tokico D spec shocks/struts..................$560
4) MMs k-member....................................$90
5) MMs rear lower control arms..................$250
6) MMs Panhard Bar.................................$330
7) MMs Heavy Duty Torque Arm.................$650
8) MMs caster camber plates.....................$200
a couple of things i'm not sure of, there is a huge difference in the way a MM k-member looks vs a k-member from other places. also a huge difference in price. i've also read that tubular a-arms need to go along with a tubular k-member. MMs site doesn't mention that but there piece doesn't look as elaborate as the QA1 (and others) piece. also, i'm not sure what springs i'd need to run in the rear.
i don't know that i'll end up going this elaborate but from what i've read up to this point it should be a pretty "sticky" setup........right?
what did i miss?