Possibly Easy But Expansive Question . . .

Good Question... if my current 2V gives out I would consider a 3v swap. I am in the process of already looking at T56 tranny swap for my car.

http://www.loganmotorsports.com/2V_to_3V_conversion.html

Check that out. I was looking at 3v swaps awhile back.

I'm also looking into a T56 swap, soon. Decided to fix my TR3650 second gear with a Magnum T56 set up.

Sent from my EVO using Tapatalk 2

If you are going to take the whole motor out and put another one in, why not go with the four valve. Its a bigger V8 motor they put in these cars to begin with. Transmission stuff should match up, might have to change clutch components and ECU. I would think that would be easier than adapting a 3 valve to fit. My 2 cents. Good luck.

Logan's kit makes it pretty much a bolt in deal. Even retains the 2v ECU (cams timing is locked out). I'd like to know are all mustang 3v blocks aluminum? I've searched and can't a definit yes or no. If they are I may revisit this idea.

What's your intent with any type of swap....are you looking for more power? Why not just rebuild the 2vs?

I'm looking to hit the occasional track day. It doesn't make alot of sense to me to put in an aluminum short block and then add all the weight back with a s/c. 3v's have better n/a potential. A coyote would be ideal, but I'd like my dash to work. The dare to be different factor is there too. Not looking to make stupid amounts of power, but I would like more that a streetable n/a 2v can make.

Sent from my EVO using Tapatalk 2

My old 2v has quite a few hard miles (214k) on it as well, so I am interested too.

The 3v swap looks pretty cool. I like the fact that someone did all the hard work of gathering all the misc. connectors, wiring, hoses, ect and offers it in a kit. Looks like around here, a 3v runs 1500-1700+tax and the kit another 1500... so with fluids and everything, it'd be around $3500-$4000. That kinda stings for 300 fwhp and and less low end torque than stock...

I have thought about a coyote swap too... but again, the whole dash thing is a bit of a problem (not to mention cost). That'd be a SWEET setup in a 96-04 car though. I drove a '13 5.0 the other day and it pulled hard in the mid and upper rpms, yet was perfectly docile and easy to drive in traffic and at slow speeds. Put that engine in a car that weighs a solid 400lbs less and enjoy.

And so it comes back to speed parts... seems like a root style blower is right in the price range of a 3v swap, but will give you 350-400 rwhp instead of 260 rwhp from a 3v. But that doesn't solve the engine with high mileage issue... I suppose you could buy a low mileage long block or run the old engine till it's too tired. I will tell you, I regularly see taxis and police cars in the j-yard with 400k miles, so the engine will go that far. 317k I would have second thoughts about a blower, but 180k is still a pup.

Thought about a Coyote swap as well. Cost didn't deter me, but someone else did on their SN95 and blew the engine pretty fast. Never said what failed so I just left it as a fleeting thought but a 3V swap I could do. I have inlaws that are gear heads and would jump at the chance to do a conversion.

Stick with the 2v , replacing the timing gear, maybe add some cams and a positive displacement blower and have fun. These motors stand up to mileage very well.