So all of the sense that I have is telling me that I'm getting wrapped around the axle on this, but here goes anyways... On my past few MAF builds I have just used the flow sheet info to set up my MAF or the dummy values for stock MAFs, except when I ran a LMAF with a Mafia back in 2006 or so and had to extend the voltage info.
Currently I have a MS and am running 36# injectors. BUT I am going back to MAF and a Quarterhorse, so... I have a 75 mm Bullet Pro-M MAF and it came with this attached flow sheet. The MAF itself has a sticker on the sensor that states "M93-36C" as the calibration. So how would I set up this MAF? Do I set up the flow sheet and do I set up the injector sizing independently? Or is this flow information bound to using 36 # injectors?
Thanks
Currently I have a MS and am running 36# injectors. BUT I am going back to MAF and a Quarterhorse, so... I have a 75 mm Bullet Pro-M MAF and it came with this attached flow sheet. The MAF itself has a sticker on the sensor that states "M93-36C" as the calibration. So how would I set up this MAF? Do I set up the flow sheet and do I set up the injector sizing independently? Or is this flow information bound to using 36 # injectors?
Thanks