Pro-m 80mm w/ 24# injectors flowsheet

[mackey]

Anyone have a flow sheet? There was one floating around the internet. The numbers were highlighted in yellow.

Any help would be appreciated.

 

[final5-0]

You could find one on the two Tweecer sites

If you got a Tweecer, there are quite a few maf curves in your
software you can call up

Grady

 

[mackey]

I Looked and could not find it. I also have the Tweecer RT so that is how I am entering it. I tried the ProM_24 calibration and it is different than the calibration that I found online. The one I found online made my car run MUCH better or else I wouldn't be looking for it.

 

[final5-0]

I found this in Paul Booth's EEC Editor Program

It was under the file name of ProM_24

Grady

15.9998 1236.287354
5 1236.287354
4.8 1107.655762
4.6 988.806885
4.4 879.275391
4.2 778.60907
4.1 731.461914
3.9 643.268494
3.7 562.854675
3.5 489.803802
3.3 423.707214
3.2 393.1409
3 336.726288
2.8 286.277405
2.6 241.412399
2.5 220.9561
2.3 183.764297
2.1 151.230103
1.9 122.994499
1.7 98.7062
1.6 87.934196
1.4 68.922699
1.2 53.011101
1 39.874199
0.8 29.1959
0.7 24.682199
0.5 17.1189
0.3 11.2653
0.1 6.8413
0 5.0812