Well, I wouldn't exactly describe myself as a dummie but I'm kinda confused. My goal is to add a push button ignition to my stang 93 LX. I don't want to use the key at all. I hear that if you eliminate the ignition tumbler (whatever it's called) that the steering will not lock. Now, how many switches do I need? I would think 1 to activate the ignition, 1 for the accessories, and 1 momentary for the starter. Next, how do I wire all these switches in? I would think that there is a circuit for each of these three function attatched to the ignition switch. Do I just run the wires to the appropriate switch and then ground the other post on the switch? Also, what current rating do I need to look for when buying my switches? Thanks in advance to anyone that can help.
Smitty
Smitty

. Alot of cars arent that hard to "hotwire",and no im not a thief or anything. when I was putting in my mom's remote start in her 97 honda, once i found out what wires were what I started it and had it running with a Paper Clip! It certainly got hot within a few seconds but with a thick wire it would have been fine to drive away with, and only took a couple screws to get to the ignition switch(or in a thiefs case he would break it apart). My mom saw her car running and she had her keys and she wanted to no how i started her car without her keys. I was like uhh a paper clip?
I also have a switch inline with my ignition and starter solenoid, (even though someone could just give it 12v from under the hood in 2 seconds), im going to add another one into my MSD box or my fuel pump just in case.