I'm just finishing replacing my first head gasket on my 85 GT. I'm wondering if I need to adjust the valves, or if I can just torque them down to 20 lbs. I removed the distributor and didn't bother making any marks to show how it was oriented before, and don't have anything discernible on crankshaft pulley (not very experienced working on cars as you can tell). Can I just put cylinder 1 at TDC and orient the rotor to point at cylinder 1? I have a timing light and everything, just need it to initially start up. And finally, the cars carbed and there are a bunch of small vacuum lines that run off it. I was planning on plugging the small ones to see which were necessary (it looks like a mess with all of them). Is that a good idea? Thanks in advance for any help!