Hey guys, I’ve been helping out my friend recently with his 04 GT. He’s got an vortech v2 and should be putting out 8-9lbs. It’s a stock 3.60 pulley, boost gauge is showing 0 psi and 20 vacuum. I noticed the tensioner pulley was slipping and replaced the belt and tensioner. Still not reading any boost. Any suggestions? I was gonna try swapping out the Bosch bypass with a Proflow, but sadly I just noticed that the inlet / discharge are completely different sizes between the Bosch and proflow. Just looking for some direction?
Side note. Already checked all clamps, all are tight and no visible cracks or holes. and I do not hear any noise from the Bosch bypass when I rev the car up.
Side note. Already checked all clamps, all are tight and no visible cracks or holes. and I do not hear any noise from the Bosch bypass when I rev the car up.