Questions about ride height

iskwezm · Jul 23, 2005

So i took my car out for the first "long" cruise with the new stroker,besides running hot and feeling like a bucking bronco at anything below 3k rpm, it runs pretty strong with out the blower

Now my question,I have Maier leafs that are about 20 years old,low miles,but probably sagging from time.The disatnce from the wheel center cap to fender lip is about 12 3/4 inches.Im going to replace them.What should i get and what is your ride height.

I should note,i have dual batteries and NOS bottle,amps and panels in the trunk if that makes any weight difference.

Thanks, Mario

70vert · Jul 24, 2005

I still don't understand how those 275 rear tires don't rub. From that one photo it looked like the rear fenders were just about sitting on the tires. Maybe it was just the wrong angle. Or maybe that's what caused your bucking problem. can't help you on the leafs, sorry . . .

iskwezm · Jul 24, 2005

70vert said:
I still don't understand how those 275 rear tires don't rub. From that one photo it looked like the rear fenders were just about sitting on the tires. Maybe it was just the wrong angle. Or maybe that's what caused your bucking problem. can't help you on the leafs, sorry . . .

It doesnt rub when its parked

Actually, i think if the springs werent so old, and i didnt have the extra wieght it would be fine.Normal driving it doesnt rub,only on major dips.

iskwezm · Jul 24, 2005

Anybody????4 leaf?5 leaf"reverse eye? Anything?

Pbum5 · Jul 24, 2005

I like my Miaer 165's

iskwezm · Jul 24, 2005

Pbum5 said:
I like my Miaer 165's

can you measure your ride height????

iskwezm · Jul 25, 2005

nobody has performance leafs on their car in here?I just need some measurements to know what springs to get.I have 650's now.

bnickel · Jul 25, 2005

i have 5 leaf mid eyes from american pony, unfortunately that won't help you much since they are sitting in the garage and not on the car yet

iskwezm · Jul 25, 2005

bnickel said:
i have 5 leaf mid eyes from american pony, unfortunately that won't help you much since they are sitting in the garage and not on the car yet

Thanks,at least i got a response

Hack · Jul 25, 2005

For what it's worth, I replaced my rear leafs with stock parts about 7 years ago. My rear fender lips are 26.75 " off the ground. I'm running 24.75" diameter tires. This is on a 1970 convertible. The back end seems way too high to me, but that should be the stock ride height. Edit: since the stock tires are about 25.9" in diameter, the rear would be about 1/2 inch higher with them.

Hopefully you'll get some answers from people with cars more similar to yours.

iskwezm · Jul 25, 2005

Hack said:
For what it's worth, I replaced my rear leafs with stock parts about 7 years ago. My rear fender lips are 26.75 " off the ground. I'm running 24.75" diameter tires. This is on a 1970 convertible. The back end seems way too high to me, but that should be the stock ride height.

Hopefully you'll get some answers from people with cars more similar to yours.

thanks,that what im hoping for

Pbum5 · Jul 25, 2005

iskwezm said:
can you measure your ride height????

Ok here are my Numbers

Maier 165 Race Springs

Ground to fender is 24”

Center of Hub to Fender 13”

Tires are 23 3/4” - 265/50 14”

There is about 1” of clearance from the tire to fender.

Hope that helps.

If you with the Maier’s they highly recommend that you run Heavy-duty shackles.
They recomended 165 over the 160's for a small block stroker.

I still need to lower the front a bit.

iskwezm · Jul 25, 2005

thanks

My dad put maier 165's on about 20+ years ago,i think their just sagging from time,not really mileage.your fender lip is about a 1/4 in higher then mine,which could be my extra wieght
so maybe they did sag that much,but might be weaker.

Questions about ride height

iskwezm

70vert

New Member

iskwezm

iskwezm

Pbum5

Member

iskwezm

iskwezm

bnickel

iskwezm

Hack

iskwezm

Pbum5

Member

iskwezm

Similar threads

Questions about ride height

New Member

Member

Member

Similar threads

Privacy & Transparency

Privacy & Transparency