R & R Help Power Window Motor

S

Sompin2do

New Member

Nov 30, 2004

59

0

0

TX

Jan 7, 2007

#1

• Jan 7, 2007

• #1

From all of my searching here it seems like it's time to R&R the driver side window motor (I hit the switch, window doesn't move, power at the gauge drops, and I can hear a slight click inside the door) on my 94 GT.
Chilton manual is descriptive enough for pulling the door apart, but can't find anything about replacing the motor. I've done these before on a Bronco, but not a Stang.
Any pointers would be helpful.

Thanks
Mike

 

bill302

Active Member

Nov 2, 2005

2,131

1

46

alabama,gadsden

Jan 7, 2007

#2

• Jan 7, 2007

• #2

motor is probably good you need to replace the torque pins click on link below for info and to buy....
http://cgi.ebay.com/ebaymotors/FORD...9QQihZ003QQcategoryZ33684QQrdZ1QQcmdZViewItem

 

bill302

Active Member

Nov 2, 2005

2,131

1

46

alabama,gadsden

Jan 7, 2007

#3

• Jan 7, 2007

• #3

check out this stangnet link below it may help....
http://forums.stangnet.com/showthread.php?t=566993&highlight=power+window+torque+pins

 

chaos254

Founding Member

Jul 27, 2002

467

3

29

NJ

Jan 7, 2007

#4

• Jan 7, 2007

• #4

check the help section in your local auto parts store. they should have them there. I think there were like 3.99. You'll see once the motor is apart if the pins are the problem and they most likely are.

 

S

Sompin2do

New Member

Nov 30, 2004

59

0

0

TX

Jan 8, 2007

#5

• Jan 8, 2007

• #5

This morning the window is working fine. Just to clarify my first post. That clicking I could hear was very faint. Could it still be the pins? Thanks for the replies.

Mike