Re-adjusting my harland sharp stud mounted?

[FordStang]

Well i installed my rockers awhile ago when i installed everything else including the heads. Pulled the valve covers off and need to re-adjust them....just need the steps to do it. As in when to adjust them when the valve slightly opens or opens all the way ect ect. Thanks guys.

reason for doing this is because all my rocker (both valves) Are alittle loose as in back and forth not up and down. They dont move off the Valve Springs but they do move somewhat. i thought when one of the valves were either open or close it isnt suppost to move at all. Thanks guys really need this info so i can drive the stang in these hot summer days.

 

[RIO5.0]

Try this...

(tech article provided by Ed Curtis of FlowTech Induction )


HYDRAULIC LIFTER/VALVE ADJUSTMENT PROCEDURE


--------------------------------------------------------------------------------

1. Remove the valve covers, and pick a cylinder you are going to set the pre-load on. Only do one cylinder at a time.

2. Rotate the engine in its normal direction of rotation (clockwise) and watch the exhaust valve on that particular cylinder. When the exhaust valve begins to open, stop and adjust that cylinder's intake rocker arm.

3. To adjust, back off the intake rocker arm adjusting nut and remove any tension from the push rod. Wait a minute or two for that hydraulic lifter to return to a neutral position. The spring inside the lifter will move the push rod seat up against the retaining lock, if you give it time to do so.

4. Twist the intake push rod with your fingers while tightening down the rocker arm. When you feel a slight resistance to the turning of the push rod, you are at "Zero Lash". Turn the adjusting nut down one half to three-quarters of a turn from that point for street applications. Use 1/8 to 1/4 turn for race applications. Lock the adjuster into position. The intake is now adjusted properly.

5. Continue to turn the engine, watching that same intake valve/rocker you just set. It will go to full open and then begin to close. When it is almost closed, stop and adjust the exhaust rocker arm on that particular cylinder. Loosen the exhaust rocker arm and follow the same procedure described before in steps 3 and 4 to adjust this rocker arm.

6. Both valves on this cylinder are now adjusted, and you can move on to your next cylinder and follow the same procedure again.

There may be some initial valvetrain noise when the engine is first fired up but once oil pressure has stabilized and the engine heats up, it should quiet right down to a normal level.

Remember that some racier camshafts will have a mechanical sound to them and will not be a silent as factory units.

 

[FordStang]

thanks!