I recently installed a set of D&D rear drag coil-overs on my '95GT. They went in well and seemed to be of good quality. However, I noticed that the 6'' of advertised adjustable ride height was really only about 3''. If you go too far with the spanner rings in either direction, the shock runs out of travel. When I adjusted them to where they needed to be, my ride height had increased what looked to be about 3'' over what it had been stock. As my car has been supported by eibach road-race springs (3'' drop) for the last four years, I could not bare to look at it. Off they came and the eibach springs/strange shocks went back on. So, SN-95 users beware of this. I should be installing my k-member, cc plates, struts, front coil-overs and a-arms in the next few weeks, so I will keep everyone posted.
