Rear end swap

If you do not want to deal with bleeding the brakes you will have to drain and pull the axles from your stocker. Remove the brake plates and pull them from the housing. Use a wire to hold them up out of the way and then get unget the housing and remove all the hard lines. They are held on by a few retainers and a vent bolt at the hard/soft line connector. Remove all the like parts from the new housing and bolt that bad boy up. I used straight synthetic lube that was reccomended for trac loc\posi rear ends.

Allen
 
86-98 Mustang 8.8 housings and 87-88 Thunderbird Turbocoupe housings are basically the exact same dimensions. If you can find a TC housing, it will have 3.55 or 3.73 gears, a plus if you want gears also. I got my TC housing for $60 without the disc brakes!

Good luck!
 
The right rear tube has a different breather/brake line set up on the 7.5 to the 8.8. The way it it threads in is different LOOKING, but it is OK. I ran into this on my notch, because it used to be a 4cyl car, but just unthread it, and put the one back in that is hanging from the car. It will work just fine.