Rear suspension bushings for '91 GT

Codosuarus

New Member
Jun 6, 2021
4
0
1
San Diego
My '91 mustang GT convertible has been sitting for about 10 years and now my son has taken an interest in it.
He pulled out the rear control arms after finding that the suspension bushings have all either melted or disintegrated.
We are looking for new suspension bushings (urethane is fine) but cant seem to find them.
I remember that I bought aftermarket rear control arms around 20 years ago, but I cant remember where I got them and they have no markings.
Any ideas where to find these suspension bushings?
If not, Is there someplace where I can buy them by dimensions?
 
  • Sponsors (?)


Here is a picture
 

Attachments

  • 20211107_022953.jpg
    20211107_022953.jpg
    411.6 KB · Views: 63
Those look like old BBK control arms, which you would use these bushings



Compare them to these (which are the 99-04 version but should look similar)


 
I had this issue on a customer car. He brought us control arms that were off the car and missing bushings. I had to measure the dimensions inside and I called prothane to get a set. Ended up needing to cut them down as they were too wide, but that wasn’t a big deal.

If I had to do it all over again, I’d just tell him to order new control arms. Since he had them powder coated to match everything else that wasn’t an option though.