I importkiller90 New Member Sep 16, 2007 59 0 0 iowa Aug 31, 2008 #1 Aug 31, 2008 #1 ive done the efi to carb swap and was wondering if i get an intake manifold without the rear water crossover will it work? the car is a 1990 mustang with a 5.0 H.O.
ive done the efi to carb swap and was wondering if i get an intake manifold without the rear water crossover will it work? the car is a 1990 mustang with a 5.0 H.O.
93 LX Founding Member Jun 2, 2000 3,081 3 0 Norwalk, CA. Aug 31, 2008 #2 Aug 31, 2008 #2 Yes it will work fine. I had a Edelbrock Torker (Original with the twisted carb mounting) and it does not have a rear water passage.
Yes it will work fine. I had a Edelbrock Torker (Original with the twisted carb mounting) and it does not have a rear water passage.
I importkiller90 New Member Sep 16, 2007 59 0 0 iowa Aug 31, 2008 #3 Aug 31, 2008 #3 thank you i was worried that my engine was going to over heat or have antifreeze go where it doesnt belong.
thank you i was worried that my engine was going to over heat or have antifreeze go where it doesnt belong.