Thanks for the info, how do the hinges attach to the car? It looks like the side pieces slide behind the window molding. I don't have the side filler pieces, are the necessary or just looks better.I have a set on my black mustang, and they mount like the picture below. The little feet on the plates slide under the back glass window mounting
These are aluminum, not sure if factory or not. Where the factory units aluminum.There are a few different louvers sets out there. There's the Ford oem louvers and a few aluminum aftermarket sets sold in the 90s. Latest versions are plastic
These are aluminum, not sure if factory or not. Where the factory units aluminum.
Thank you very much, that's the info I was looking for. I don't see any side pieces on there either.My '83 GT had either factory or dealership installed rear louvers. They were metal with either thin gauge steel or aluminum mounting brackets/hinges. The top edge brackets were hinged so you could loosen the lower nuts to raise the louver for cleaning the rear window. The brackets fit underneath the molding and were double-stick taped to the glass. I decided not to re-install after the paint job and recently got rid of the louvers and hardware (sorry). Here is a picture but you cannot see the hardware much, only the cap nuts. By the way, another way to ding up your louvers is to back into the half open garage door (see photo).
sorry about that garage door!!Thank you very much, that's the info I was looking for. I don't see any side pieces on there either.
So you were the one that left it halfway down?sorry about that garage door!!
thank you very muchHere are the Ford accessory rear louvers. Out of 1987 brochure
Here's the 1979 brochure. Slighter fewer slats, so there were a few styles from Ford
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?