Redline shift boot install

Flip the handle over and look into it. You should see a slot where the spring will fit and, with the spring in place, the black pushbutton will stay out. Basically, the black button when pushed forces a wedge to force the white button down. The spring puts the wedge back out of the way of the white button.

Here's a bad sketch: button-pipe-wedge where the pipe holds the spring...

[]====/
............A white knob
.............| shifter handle
.............|
.............|

(ignore the periods -- they're needed to get the vertical bars lined up)

Do you see it?

You probably know but there is a tiny Allen screw on the knob at 12 o'clock as you look at the top of the plastic handle and down the shifter shaft. Don't forget to plug the OD wire back in!

HTH,

Chris