• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Removing the doors and harness Q,s

  • Thread starter Thread starter biggmac
  • Start date Start date Jun 13, 2009

biggmac

New Member
Jul 15, 2008
5
0
0
Northern California
Jun 13, 2009
#1
  • Jun 13, 2009
  • #1
From experience is it better to unplug the harness to remove the doors from the inside under dash and pull door the out, or unplug harness on the door and leave connected to the car/dash. Thanks
1992 GT 5.0
 

RYC CUKR

Founding Member
May 19, 2002
1,437
1
38
Orlando
Jun 13, 2009
#2
  • Jun 13, 2009
  • #2
I unplugged mine under the dash and then pulled the doors.

Be prepared it is pretty tight up there, it was a real pita.
 

trbkrb

Founding Member
Jun 4, 2001
1,976
4
39
Houston, TX
Jun 14, 2009
#3
  • Jun 14, 2009
  • #3
I haven't changed my doors, but I have installed the power harness and I would NOT remove the rubber boot from the dash side again unless the dash is removed. It was a royal PITA trying to get the rubber boot to snap in place and seal with the limited room under the dash to pull it in place. The door side was easy since there is much more room.

Good luck!
 
L

Lawbreaker5.0

Member
Feb 20, 2009
543
2
18
Texas
Jun 14, 2009
#4
  • Jun 14, 2009
  • #4
unplug from under the dash, but like previously stated its a pain trying to connect them back together
 

biggmac

New Member
Jul 15, 2008
5
0
0
Northern California
Jun 14, 2009
#5
  • Jun 14, 2009
  • #5
Cool Thanks........Just got done removing door and unpluging from under dash. Mine wasnt That bad to do, it was pretty quick to re-plug also,, again Thanks!
 
You must log in or register to reply here.

Similar threads

F
Electrical Foxbody wiring harness 2.3 to v8 swap
  • Foxbodyjake
  • Mar 23, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
24
Views
717
Fox 5.0 Mustang Tech Apr 13, 2026
Foxbodyjake
F
J
Electrical Engine harness replacement
  • Jarhead67
  • Aug 23, 2025
  • Fox 5.0 Mustang Tech
Replies
6
Views
253
Fox 5.0 Mustang Tech Aug 27, 2025
Jarhead67
J
C
Electrical HELP! 1989 5.0 Stick, Voltage Bleed onto Ignition Trigger wire
  • ChickenDeluxe
  • May 14, 2026
  • Fox 5.0 Mustang Tech
Replies
7
Views
234
Fox 5.0 Mustang Tech May 24, 2026
ChickenDeluxe
C
F
Electrical From scratch: alternator wiring
  • fox racer v2
  • Jun 23, 2025
  • Fox 5.0 Mustang Tech
Replies
0
Views
574
Fox 5.0 Mustang Tech Jun 23, 2025
fox racer v2
F
N
Power door lock motor Question
  • NYFox
  • Mar 15, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
267
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Mar 17, 2026
NYFox
N
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?