Retorqueing intake after install?

willys1

Active Member
Dec 2, 2003
1,004
1
36
New Jersey
Just like it says,,I have a few thousand miles on the motor after putting on Thumper heads.A few of the bolts on the intake werent to tight on the lower(the ones in view) Should I take off the upper and retorque the bolts on the lower? Anyone else have this problem?
 
Retorque the lower intake bolts!!!

The last time I reinstalled my intake a couple years ago,I didn`t retorque the lower bolts after running it a while,I figured since I went over the final torque sequence numerous times until they were all even and torqued down,that it wasn`t necessary...
after all,nobody retorques them after they leave the factory,and they don`t seem to leak after they leave the factory.

Just under a year later I noticed a very slight coolant leak at the front of the lower intake manifold.Sure enough they were a little loose when I went to retorque them.After the retorque,the slight leak disappeared.