• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 V6 Mustang Tech

Rod knock?

  • Thread starter Thread starter Red89Notch
  • Start date Start date Aug 12, 2005

Red89Notch

New Member
Sep 6, 2001
4
0
0
Victoria BC
Aug 12, 2005
#1
  • Aug 12, 2005
  • #1
Hi,

I have a 1995 V6 that has what I think may be a rod knock. Or possibly it is a dead lifter. Basically the symptom is that if I start the car when cold I'll hear a clack for second or two until oil pressure builds. Part of the problem is the crap Fram oil filter I was using letting oil drain out of the top end of the engine, but even now after I've switched to a better one, I'll still hear hints of the noise at higher RPMs, or sometimes as the engine is coming back down if I rev it. It is barely perceptable at idle or under 2500rpm.

I've never had an engine with rod knock before, so I can't tell if it is a rod issue or a valve/lifter issue.
 
C

cobra232

New Member
Mar 10, 2004
233
0
0
Aug 12, 2005
#2
  • Aug 12, 2005
  • #2
fram is a fine filter and has nothing to do with oil drainback into the pan from the heads.

if you have rod knock just rebuild the engine.

95 were known for head gaskets leaks.

are you sure you don't have a leaky gasket causing a light hydrolock?

you may have both problems now. leaky head gasket that cause a rod knock.


my opinion just get a 97 or 98 engine and replace you original with it.

you can find them at www.stangparts.com

or a performance built 3.8 at www.rpm-mustangs.com

do a compression test on all 6 cyl's use a scope to hear if the rods are knocking in the bottom or just valvetrain noise which the 3.8 is known for
 
You must log in or register to reply here.

Similar threads

B
Engine Strange Noise
  • burntokita
  • May 8, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
405
Fox 5.0 Mustang Tech May 11, 2026
keel
H
Ongoing Battle With Hydraulic Lifters
  • hailer06
  • Jun 8, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
7
Views
304
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 9, 2026
Noobz347
Y
Engine 1994 Ford Mustang Gt Rod Knock/Stuck Lifter
  • yaboity
  • Jun 7, 2025
  • 1994 - 1995 Specific Tech
Replies
2
Views
277
1994 - 1995 Specific Tech Jun 8, 2025
AeroCoupe
U
8 Years of Vibration leading to engine knock?
  • UpgradeXP
  • Apr 14, 2025
  • SN95 V6 Mustang Tech
Replies
3
Views
469
SN95 V6 Mustang Tech Apr 14, 2025
Noobz347
W
Electrical 91 GT Alternator Replacement Question
  • willrh111
  • Oct 22, 2025
  • Fox 5.0 Mustang Tech
Replies
6
Views
376
Fox 5.0 Mustang Tech Oct 23, 2025
nickyb
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 V6 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?