I'm installing a 8 point S & W roll bar in my 93lx. I found it easier to fish plate the floor pan with top and bottom plates and sandwich the floor pan by tighten the 4 3/8" bolts. I'm going to run a few stringers along the top plate corners for extra strength.
The main hoop need both bottom end trimmed about a inch or two. I have the 1 3/4" mild steel tubing. Can I use a plumber's pipe cutter to cut the pieces off?
The main hoop need both bottom end trimmed about a inch or two. I have the 1 3/4" mild steel tubing. Can I use a plumber's pipe cutter to cut the pieces off?
