roll cages

[KC95GT]

Haven't posted on here in a while, but I'm about to put a roll cage in my car now that its hit 11.50's. Can anyone on here post pictures of 6 and 8 pt. cages in there 94-95's? Trying to get some ideas. Thanks
-Casey

 

[Killercanary]

Check out http://www.rhodescustomauto.com/

They do AWESOME work from what hear. They have pics up on their site of some Sn95 cars they've done.

 

[KC95GT]

Thanks for the link. My dad is a mechanic, so we are going to try and weld the cage in our self. I'm just looking for some pics of what it should look like to give me an idea before we start.

 

[SlowGT]

 

[SlowGT]

you like that 'X' ??

Since the pictures aren't cooperating, try this LINK to my cage pics. This one was put in by Competition Engineering.

 

[KC95GT]

thanks. How hard is it to get in and out of the car? I'm wondering if its worth it to buy the swing out side bars.

 

[Joes95GT]

Thanks for the link Paul. They're about an hour away and my Dad is really stressing about the "safety issues" with my car. Assuming they sell pre-fabbed kits, this looks like the place I'll be buying it from.

Thanks again for the link.

Joe

 

[Killercanary]

Joe, send me an email at [email protected] and I'll tell you more about them... its ALL GOOD!

 

[blown91stang]

i can take a pics of my 6 point from maxumim motor sport if you want..

 

[SlowGT]

thanks. How hard is it to get in and out of the car? I'm wondering if its worth it to buy the swing out side bars.

It's not too bad once you get used to it. Your call on the swingout. I'm not sure I'd trust the latch/pin on a swingout for a serious side impact, but it'd be better than no bar at all. It'd be very handy if you wanted to run the street without it and then just put it in at the track when it's required. For chassis purposes, I would want it to be solid, not swingout. JMO