Rolling The Fenders?

CoupedUp

Banned
Aug 26, 2005
260
0
0
Gone Fishing
I've never had to do it, but might have to.
I'm a mechanical person and don't meddle in bodywork as I fear screwing things up.
I was hoping some people could detail the technique employed to do the job without destroying the exterior appearance of the fenders.

What did you do? How'd it work out for you?
Pics are great too. Thanks in advance :nice:
 
why do you need to roll it, there is no need for that kind of stuff here at my pops shop, we just fix it (bodywork) and paint it... if all it is is your fenders, why not just have it fixed, its the lower fender so you could get away w/ painting ONLY the fenders, no blending into the doors (unless totally necessary, haven't seen your car's problem so can't really help TOO much) good luck man!
Paul Perreca
 
OH yeah, some use a baseball bat. There is a link to an acura site (IIRC) about how to do that.

I am about to do it myself :D

Anyone ever use like a ball-peen hammer too?
 
Look Its Aaron said:
Are you refering to me Hissin?
Yep - I used to see you post fairly often in Tech - now I think you might be in Talk more often. Your stuff used to crack me up.

Derek, LIA is a funny guy - Dude seemed appropriate. :D
 
Haha plus I'm from cali where I still call my mom and dad dude every now and then and I'm 22. I'll probably be 56 still saying dude. Haha

Yea Hissin I wasn't around for a while, but I am stangnet more often now, you will see my smart a$$ get people pissed off again now haha
 
What I did is probably not the recommended way.

I used a pry bar at first, prying against the tire. I do not recommend this, but I had to get to work the next day.

Later I took a 5lb sledge to the lip. This worked fairly well, but cracked all the paint on the exterior edge of the lip. I was later told by a friend that heating the paint with a heat gun can make it more pliable when bending the metal. I have not tried this but it sounds good in theory. Be sure to go slow, and only swing as hard as needed to get the metal to bend. You don't want to warp the outer surfaces.
There are a few tack welds or something that make a few spots on the lip tougher to smooth out, but make sure that you do not leave any rough edges behind, even if it lookse like you have plenty of room. The tires are rather dynamic in relation to the body, and will shift around, especially when you hit a bump in a corner.

The flaring tool is definatley the way to go, but if you have a heat gun I would break it out. It may save you from repainting.

jason