This is a very tricky and involved question. I just recently went through this dilema on my lowered 93. First off, I did a Baer rear conversion which extends the rear track .20" on each side:
View attachment 504001
I also used authentic 99-04 18x9 Saleen rims. If you didn't know, the real Saleens have a front offset of 24mm and a rear offset of 12mm. When I put the rear wheel on (12mm offset) with a 265/35/18 tire, it looked great but it was extremely obvious that it would rub the crap out of my fender. I then put on a 255/35/18 tire. This time I drove it and it did rub the fender badly. I finally got a second pair of front Saleen rims and used them on the back with a 255/35/18 tire. No rubbing, no rolling the fender, and I really like the way it looks.
Bottom line: If you go with replicas (which are a 24mm for all four) and keep the rear stock track width then you will not have to roll the fender (assuming you aren't stuffing a 315 tire in there). You will likely have to run a 1/8" spacer to clear the inner fender. I didn't have to do this since my track width is .20" wider than stock.
If you use real Saleen rims you can run 4 fronts without rolling the rear fenders. If you keep the rear 12mm offset on the rear then they will work with on a stock track width and fender rolling. I just did not want to roll my fender.
If you run the sn95 rear axles with a 24mm 9" wide rim then I guarntee you would be required to roll the fender. You will not be able to use the 12mm offset rear Saleens with this setup. Good luck.
Sorry to the original poster - not trying to hijack the thread