s351 wing

[96darkhorse]

anybody know what size threads do the studs on these have? anybody know where i can get them? the wing on my car didnt come with any studs and they used bolts to hold it down( not a good idea) can i put new studs on it or will i have to get a new wing with teh studs??? thanks

 

[96darkhorse]

ttt

 

[94TURBO5 O]

I went to HD to the hardware section and they sell threaded rods. I just cut 4 pieces off and I was set. I actually took the wing into the store to find the right threads.

 

[96darkhorse]

thanks sc50 :NICE:

hey do you remember what size was the rod??? did the rod fit or snug in perfect? did you need anything else??? how is it holding? thanks

 

[WhiteDevil]

They come from saleen using bolts instead of studs. They work fine. Its held on my S-351 for the last year and a half.

 

[96darkhorse]

whatsup whitedevil

pm me your paypal address dude so i can send the cash


my wing is missing the studs or bolts so im trying to find some to put on

 

[94TURBO5 O]

They come from saleen using bolts instead of studs. They work fine. Its held on my S-351 for the last year and a half.

I went and got the same thing after the threaded rod b/c the nut inside the wing would turn and it was hard to get the nut off the end or tighten it when I wanted to switch it out. If you going to use it permanent then the rods will work fine and they fit perfect all you need is some nuts and washers. I don't remember the size. I would put in some threaded bolts instead of the rods if you can get them, just measure them against your stock bolts for correct length.

 

[96darkhorse]

hey 94sc50 did the rods fit perfect???

 

[WhiteDevil]

whatsup whitedevil

pm me your paypal address dude so i can send the cash


my wing is missing the studs or bolts so im trying to find some to put on

PM sent

 

[94TURBO5 O]

It's a threaded rod you cut to length whatever size you want . You buy it in like a 1ft piece and yes it screwed in just perfect after I cut off 4 pieces.

 

[96darkhorse]

thanks 94sc50

i went to HD earlier and i took the wing with me and i asked for suggestions but they didint have a clue how to do it

 

[mytight95]

go get some 1/4" allthread, and find 4nuts, and 4 washers to thread onto it.....

I did this when installing my last one.....based on Jr's suggestion......worked great.....


jason