Hey guys, while mine's soaking in penetrating oil, how do you seperate the fan blades from the fan motor. I already pulled the 3 10's off and the clip, yet it still refuses to break loose.Any suggestions? Thanks!
Seperating Fan from fan motor
- Thread starter Nik_95Cobra
- Start date
95Cobra302
Founding Member
There should be a small metal bump by the clip you took off, you have to cut it off using a saw or dremel tool and the fan will come off.
Thanks for the reply man. I actually just wound up ordering the complete Fan/Motor/Shroud setup from the dealer. They didn't sell the motor seprately and I didn't want to run a napa one or something (not that it matters just personal prefrance). Hopefully she'll be up and running soon. 
95YellowGTbeasT
New Member
95Cobra302
Founding Member
Hey Nik 95 Cobra, just ordered some mac ceramic shorties for my cobra, did you notice any sound difference or a little bit of power gain???
Noticed no power gains. As for the sound, it was much louder, slightly crappier sounding (if that's possible with bassanis). I don't like em, I can't wait to throw some longtubes in.
bjl95mustang
Founding Member
Autozone sells the siemens s/p motors for $60. It's the same brand that was on mine and I think it has a lifetime warranty. The old onr said ford and it was made by siemens.
95Cobra302
Founding Member
Damn that sucks, I think it will sound much better on my off road H, mac cat-back!!!! Sounds good already.
Similar threads
