SFC Question

Shakerhood · May 16, 2005

I had my MM Subframe connectors welded in this week. The guy that did it only had a wire feed welder, do you think I will have any problems in the future having it done this way? It feels real solid and the welds look like they penetrated ok. I have just heard people say to MIG them in only and I didnt know if it was that important.

stang22 · May 16, 2005

It was probably a wire-feed MIG welder, more than likely. Did he use gas? That's how I welded mine in, as I am sure that's how most everyone here welded thiers in. You will be ok.

Tim

Shakerhood · May 16, 2005

stang22 said:
It was probably a wire-feed MIG welder, more than likely. Did he use gas? That's how I welded mine in, as I am sure that's how most everyone here welded thiers in. You will be ok.

Tim

No, All he had was the flux core wire feed, no gas. I wish it would have been a mig set up.

stang22 · May 16, 2005

You will be ok... As long as the welds penetrated good, nothing to worry about. I have ran out of gas when MIG welding, I am guessing it is the same thing or same welds, but with much more splatter. That's seems to be the only difference to me anyway, but I am not the pro like some of these guys on this site.

Tim

Shakerhood · May 16, 2005

We cleaned them up real good afterwards and they look like the penetrated pretty well, I guess I am being worried about nothing.

SFC Question

Shakerhood

stang22

Active Member

Shakerhood

stang22

Active Member

Shakerhood

Similar threads

SFC Question

Shakerhood

stang22

Active Member

Shakerhood

stang22

Active Member

Shakerhood

Similar threads

Privacy & Transparency

Privacy & Transparency