SN95 Dash in a Fox Body

You basically have to fabricate the console out of fiberglass, and to do it right, cut it in half and take a section out of the center. Then after that you've got to deal with all the wiring issues with the dash...BUT, if you're lucky enough to afford a 4.6 swap, you'll have the right dash and the right computer to go along with it.

I got this pic off here a few years back....no idea who it is. I have the pic labeled as an '85. If i remember correctly, most of what you see was custom, and there was a pretty good loss of leg room because the dash comes out much further than the stocker.

the guy who did it mocked it up in another fox without a windshield and then transfered it into his fox took alot of hours. I think it took like 9 hours of trimming just the dash in the mockup car.

Doesn't work in my opinion with the lines of the earlier 5.0s....and obviously a lot of hard work to boot.

about 4 or 5 years ago aguy did it here on stangnet and tool lots of pics, dunno if the info in still here. He had to cut lots of stuff, he broke his windsheild, he had to relocate his inner door handles , lots and lots of stuff, but it looked sweet