SN95 Wheel Bearing Replacement. How hard?

[5LugFoxFanatic]

How hard is it to replace the hub/wheel bearing on a SN95? I have my passenger front that is humming and would like to get that out of there. Do I just remove the big center nut and then remove it, or do I need a few more tools than that? For example, something to pry it off?

 

[194stang]

thats about it, youll have to pull the rotor and caliper, then get ready, that big nut is tight--like 200-300 ft lbs, (dont remember the exact figure) then pop the new one on and tourque it down. Good luck!

 

[5LugFoxFanatic]

thats about it, youll have to pull the rotor and caliper, then get ready, that big nut is tight--like 200-300 ft lbs, (dont remember the exact figure) then pop the new one on and tourque it down. Good luck!

Thanks man!

 

[dannydoo]

make sure it aint just loose..mine did it too and it just needed a few turns..but i caught it pretty fast..
\simple to change....that bolt is a pita sometimes...
the rears are impossible..have to pull the whole rear apart!!

its easy...the front...i did mine in 20 minutes air gun

 

[5LugFoxFanatic]

Yeah the rear are a PITA, but I replaced them with the axle seals when I did ny 5 lug conversion. If I remember right, you have to remove the axles. I think I sanded mine down to make a smooth seal. But yeah they are done. But thanks for lookin' out.