ok.. the install went down yesterday in about 5 and a half hours. first time i did this. it was easy and straight forward.. but i have a question on the lower coil placement. i put the new springs in just like the shop had my h&r ss's in there. i always noticed my the ss's were uneven in the back by just a tad. with that said.. i just followed direction on the sn install guide..which dosent say much about spring placement. when i was just now reading mw spring install guide, it says to place each spring on the rear facing the drivers side. what i did was face each lower coil towrd the car.. ( pointing "in" if you will).. so my passenger side of the car is right (facing the drivers side).. but is my lower coil on the drivers side backwad? i noticed last night after everything was done that the drivers side in the rear sat higher than the passenger side. would this be the prob. do i need to rotate that rear drivers side spring 180 degrees? i hope not, but from the looks of the way its sittin somethin is off by about quarter inch.
another problem with the sn install guide is that it says to disconnect the brake hose line bracket (fronts).. and i figured (i guess like everybody else) that that instuction is wrong, its the abs line bracket, so somebody might wana change that so ppl like me dont waste time.. at least it was only 10 min (bolt is near impossible to get to also)
another problem with the sn install guide is that it says to disconnect the brake hose line bracket (fronts).. and i figured (i guess like everybody else) that that instuction is wrong, its the abs line bracket, so somebody might wana change that so ppl like me dont waste time.. at least it was only 10 min (bolt is near impossible to get to also)