starter

32785stang

New Member
Nov 23, 2006
30
0
0
I juts bought procomp electronics high tourqe mini starter from mustangs unlimited part no. PC2107 the only problem is it has a solenoid on the starter. Whats the best way to wire it when im still using the fender mounted solenoid. theres no tech line for the damn company either. guess thats what you get for a $90 starter
 
that solenoid on the starter engages/disengages the starter motor gear to/from the flywheel/flex plate. the solenoid on the fender well only relays power to the starter solenoid when you hit the ignition switch. they are two totally seperate items.
 
since the mini-starter has its own built in relay (that is triggered by the small 12-ga wire), the fender mounted relay isnt even necessary. but i recomened using it. you could wire it up like this....

ministarter.webp


On the diagram on the right for the mini-starter, you can see the small "12V key" wire going into the fender relay, and then a small wire going from the right hand (output) side of the fender relay and down to the starter. you could bypass the fender mounted relay altogether and just connect the small 12V key wire directly down to the starter to act as the trigger? Right now with the way it's set up, you basically have a relay (on the fender) triggering another relay (on the starter). Seems redundant.

If you did this, the fender mounted relay would basically just act as a terminal block for the starter constant hot/battery/alt/other wires coming together, and you would like to clean this up and use a nicer terminal block such as the one pictured below. this should work. maybe JRICHKER or someone with a little more electrical insite can help you better if this doesnt work.

cn-1.s15.jpg
[/
 
i just did this, the small wire goes on the right side of the relay and the big wire goes
on the left side (the same terminal as the battery) i re-ran the wires down and around the oil pan, so it did not go ne where the headers. hope this helped.