Starting Issue (neutral safety?)

ShallowGrave

Founding Member
Sep 30, 2001
371
0
16
Philadelphia
ok, first let me say that I did search...

92 5.0 w/t5 (ex 2.3 auto)

I turn the key, pump primes and bells ding but I get nothing from the starter.
I charged the battery (car not driven in 2 years), checked the cables and replaced the solenoid but no luck. I can get the car to crank and start if I jump the 2 big poles on the solenoid which has me thinking one of the two neutral (clutch) safety switches is bad.

Anyone agree? How do I test em? :shrug:
 
pull the 4 wire connector off the T5, its on the driver side....jump the pink and white wires ( i beleive those are the colors), thats for the NSS on the tranny....the other wires are for cruise control. if it works then you know the tranny NSS is bad.....as far as the clutch pedal switch goes...idk how you would test that. is your foot completely on the floor? i know in mine if i dont have it touchin the floor it wont start
 
For the clutch safety switch, Just look for 12 volts at the S-terminal on the solenoid while cranking. If none, check the actual CSS by lookin for 12 volts into the switch during cranking, and egressing it while the switch is closed.
If no input to the CSS, check the ignition switch.

Good luck.
 
ShallowGrave said:
thanks. I just found a burnt out wire under the dash leading to the alarm system so it may not be the NSS after all. I'll keep you posted.
If it was part of the starter interlock/starter kill wiring for the alarm, you might have found the issue. If you find a starter kill relay, you can do quick testing right there to see if you have continuity (between terminals 30 and 87A for most starter kill relays).

Good luck.
 
ShallowGrave said:
fixed it. Alarm wire chafed and burned out both the fuse and a section of wire. Thanks for the ideas
I'm glad you found that - it wouldnt have been anything I would have readily thought of as likely.

Nice work!