steeda pullies and adjuster?

98MACH1R

I wanna put it in so bad, please help.
Jun 6, 2005
131
0
0
i have a 98 gt n/a with a few minor things but i want underdrive pullies and timing adjuster so i ordered these from steeda and now my question is how do i use the adjuster i know nothing about timing and how it works but in you guys opinions what would you set the timing at? :shrug:
 
All you have to do is align the notches on the adjuster and set the screws. Some sources have reported that the adjuster is actually 1 degree off on the negative side (which means if you have it set @13 it might actually be 12 degrees advancement.) What octane gas is available in your area? This will be a critical factor in how much you can advance your timing without detonation. I can only get 91 octane here in Denver and I had the best results with 14 degrees advance with no detonation. Some people advance the timing until they hear detonation and then retard it until it goes away. One good test for this is the drive your car up a hill in fourth gear. There are also a lot of posts on this subject so do a search and you should get all of the info that you need! Good luck!
 
one thing to note is that the TA while nice for peak HP really makes more power down on the lower end. the lower torque raised is the big thing with the TA. I'm still torn if i want to go TA or just hold out till i need to get a SCT chip and tune the timing in myself...

as far as how to do it I'd raise it one notch at a time going up a hill from around 2krpm to redline and stop advancing when you hear detonation... just like said above. really is the best way.... oh, make sure you have all the 87 octane out of the tank before you ramp it up :P i'd say your second full tank of 91 would be when i'd find your end point :)

Torinalth