• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Stereo Woes!

  • Thread starter Thread starter Dan5.OH
  • Start date Start date Oct 3, 2010
D

Dan5.OH

New Member
Sep 7, 2010
3
0
0
Santa Barbara, CA
Oct 3, 2010
#1
  • Oct 3, 2010
  • #1
Hi all,
This is my first post here, and I apologize if this topic has been discussed, but I couldnt find anything when I searched. I recently installed an aftermarket head unit in my 91, and had to bypass the factory amp. I removed the outbound plug from the amp, and just tested each wire to find out what wires played what speaker.

Here is the problem: when I first turn the car on, the system sounds great, but after a few minutes, the speakers start to crackle pretty bad. Sounds similar to blown speakers. I do bnot believ the speakers are blown though, because like I said, they sound great sometimes, with no crackling at all. What would cause this?

Also, what size battery should I be using on the car (91 GT)?

Thanks Everyone!

Daniel
 
P

powershift46

Founding Member
Apr 22, 2002
366
0
17
NW IA
Oct 3, 2010
#2
  • Oct 3, 2010
  • #2
test what the OHm load is on each speaker if it is not compatible with the deck the internal amp on the deck may be overheating. Also modern head units dont like speakers with a common ground, make sure each speaker has a positive and negative that go only to the head unit.
 

93project

Active Member
Apr 21, 2009
549
52
38
El Paso, tx
Oct 3, 2010
#3
  • Oct 3, 2010
  • #3
i would rewire the entire stereo system. i ran my own larger gauge speaker directly from the receiver and some rca's to the amp in the back for a sub. if you want to power all the speakers through a 4 channel amp, the wiring will be more involved.
 

ID89GT

10 Year Member
May 26, 2008
1,659
18
49
Spokane Valley, WA
Oct 3, 2010
#4
  • Oct 3, 2010
  • #4
I agree with rewiring the whole system. The stock wiring is so small and can cause it to become distorted. I ran all new speaker wire in my 89 and it sounds great. I just used a 14 gauge I think, Idk the stuff they have at wal mart. The thicker the wiring the more power you can get to the speaker.
 
R

RatStang

New Member
Feb 11, 2010
544
0
0
Oct 3, 2010
#5
  • Oct 3, 2010
  • #5
Since you're doing all of that... might as well replace the in-dash speakers with some factory replacements from Alpine or (enter your favorite brand here).
 
D

Dan5.OH

New Member
Sep 7, 2010
3
0
0
Santa Barbara, CA
Oct 4, 2010
#6
  • Oct 4, 2010
  • #6
DontGivaRatz said:
Since you're doing all of that... might as well replace the in-dash speakers with some factory replacements from Alpine or (enter your favorite brand here).
Click to expand...

the speakers that are in it now should be fine, it has some Pioneers of some sort. Are there any specific kits made with color coded wire that i should be looking for?

Also, what size battery should I have in the car? Seems like the battery may be too small, as the alternator is fine, but if I have the stereo on with the car off for any more than 10-15 mins the battery is dead.
 

93project

Active Member
Apr 21, 2009
549
52
38
El Paso, tx
Oct 4, 2010
#7
  • Oct 4, 2010
  • #7
Most of us run sn95 alternators. 130amp, one wire. easy! Stock fox body alternators are built for go cart electrical systems. Aftermarket stereo with amp(s), electric fans, MSD boxes all draw from your battery, the weakass stock alt can't keep up.
As for battery, size really isn't the issue, it's cold cranking amps, and reserve capacity. A battery with high reserve capacity can run longer without the car before being sapped of charge. browse your auto parts store(I work at Oreilly's so ,sweet discount! ) for a high cca/ca number, and ask about their reserve capacity. Of course, the employees will try to get you to buy an Optima, and they should. Those batteries can take a beating! High numbers all around.
 

93project

Active Member
Apr 21, 2009
549
52
38
El Paso, tx
Oct 4, 2010
#8
  • Oct 4, 2010
  • #8
By the way, i have my battery in the hatch area, with an amp next to it. I used 1/0 gauge power cable and grounded in the spare tire well. Nice easy set up
 

95Vert383AOD

15 Year Member
Jun 10, 2008
1,133
34
69
New Bedford, MA
Oct 5, 2010
#9
  • Oct 5, 2010
  • #9
i wired a stereo in a 90 notch before. it had a common ground in the rear. Cheapest way around it is running a second ground wire from the head unit straight to the speaker. But personally for the price of speaker wire i rather wire everything from the ground up.....including wiring the constant positive straight to the battery.
 
You must log in or register to reply here.

Similar threads

S
Stereo snakes nest; what am I missing?
  • Scott_S
  • Aug 29, 2025
  • Mustang Sound & Shine All
Replies
3
Views
323
Mustang Sound & Shine All Sep 24, 2025
Scott_S
S
W
Electrical 91 GT Alternator Replacement Question
  • willrh111
  • Oct 22, 2025
  • Fox 5.0 Mustang Tech
Replies
6
Views
303
Fox 5.0 Mustang Tech Oct 23, 2025
nickyb
89 GT Convertible Rear Speakers Quieter Than Front
  • JulianR
  • Feb 24, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
7
Views
436
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Feb 26, 2025
Noobz347
Electrical MSD Blaster TFI Coil 8227 loud Chirping Noise.
  • PonyGTrider
  • May 25, 2025
  • Fox 5.0 Mustang Tech
  • 2
Replies
25
Views
909
Fox 5.0 Mustang Tech May 31, 2025
PonyGTrider
Run a 5 channel or use head unit and mono amp for sub?
  • 2000xp8
  • Sep 20, 2024
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
7
Views
1K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Sep 23, 2024
2000xp8
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?