• Mustang Forums
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • Classic Mustang Specific Tech

Strange oil leak, squeek

  • Thread starter Thread starter Rapid
  • Start date Start date Jan 23, 2007
R

Rapid

New Member
Mar 31, 2005
297
1
0
Columbia, SC
Jan 23, 2007
#1
  • Jan 23, 2007
  • #1
I ahev an oil leak that is driving me nuts. On occasion, ususlly after I have run uo the RPM, I get a spray of oil that gets on the underside of the hood just above the fuel pump. Oil ends up on the flat part of the top of the fuel pump. The pump is an Edelbrock. Is there a place where ol under pressure can squirt out of the pump upward?? Or any where else around there?

The spring perch squeeks. Any cure other than replacement? I am looking at the poly unit from CJ Pony that has a greese fitting.
 

dennis112

15 Year Member
May 15, 2005
1,561
36
79
Amish Wonderland of Central PA.
Jan 23, 2007
#2
  • Jan 23, 2007
  • #2
Rapid said:
I

The spring perch squeeks. Any cure other than replacement? I am looking at the poly unit from CJ Pony that has a greese fitting.
Click to expand...

Are you sure it is the spring perch that squeaks? The upper control arms are notorious for that as they wear. Maybe a shot of grease may help if yours has the zerk fittings.
 

jcode68

Active Member
Jul 15, 2003
892
1
29
Massachussetts
Jan 23, 2007
#3
  • Jan 23, 2007
  • #3
The oil pressure sending unit attaches to the block right above the fuel pump and is probably leaking. This would be under pressure, so give it a check. If you have power steering, it's a little tight to get to without removing the pump. If no PS, then you should have a straight shot at it.
 
R

Rapid

New Member
Mar 31, 2005
297
1
0
Columbia, SC
Jan 24, 2007
#4
  • Jan 24, 2007
  • #4
I removed the oil sending unit, put on fresh teflon tape at both ends of the tube and replaced. Still there. I also have changed oil filters, sending units, moved the PCV to the dirvers side and the breather to the passenger to eliminate that. ??

It is killing me.

Since the oil gathers at the top of the fuel pump and sprays up I was wondering if there is a way it could be the culprit. I can not see why,

Thanks
 

tos

Founding Member
Apr 27, 2001
896
68
59
Cincinnati Ohio
Jan 24, 2007
#5
  • Jan 24, 2007
  • #5
Its not likely that it is coming from your fuel pump. That fuel pump arm is splash lubricated. Although stranger things have happened.

I didnt see in your post that you changed the sending unit. Those housings on those units are crimped together and are notorious for leaking/spraying so check it closley. Maybe rev the engine and keep an eye on it.

Also the sending unit tube occasionaly cracks so checkit ove good.
 

tos

Founding Member
Apr 27, 2001
896
68
59
Cincinnati Ohio
Jan 24, 2007
#6
  • Jan 24, 2007
  • #6
Also if you have a oil pressure gauge then check your compression fitting and hose.
 

tos

Founding Member
Apr 27, 2001
896
68
59
Cincinnati Ohio
Jan 24, 2007
#7
  • Jan 24, 2007
  • #7
Rapid said:
sending units,
Click to expand...

Oops. I didnt read very closely.
 

jcode68

Active Member
Jul 15, 2003
892
1
29
Massachussetts
Jan 24, 2007
#8
  • Jan 24, 2007
  • #8
If you cannot visually see the leak happen whil the hood is up and you rev the engine, then it's time to get an oil leak detection kit, which is essentially a special dye and flashlight that will allow you to trace the leak. Lastly, does your car have power steering? If so, are you sure this is oil and not PS fluid? It's likely that the PS fluid would only leak while you turn the steering wheel, which builds more pressure. Would explain not being able to see a leak whil under the hood. Give us some more details and we can try to help more.
 
6

68RCodeConv

New Member
Oct 2, 2003
345
0
0
Houston, TX
Jan 24, 2007
#9
  • Jan 24, 2007
  • #9
What type of cap do you have on the valve cover? Do the valve covers have baffles in them? At high rpms a LOT of oil can build up inside the valve covers and blow out the filler cap. Wrap the filler cap in a rag and see if it gets soaked with oil the next time you do it.
 

tos

Founding Member
Apr 27, 2001
896
68
59
Cincinnati Ohio
Jan 24, 2007
#10
  • Jan 24, 2007
  • #10
jcode68 said:
does your car have power steering? If so, are you sure this is oil and not PS fluid? It's likely that the PS fluid would only leak while you turn the steering wheel, which builds more pressure.
Click to expand...


This is also a good point and could be the cause of the strange squeel. Low ps fluid can cause your ps pump to make strange noises.
 

fasttback

New Member
Apr 16, 2005
471
0
0
Northern CA
Jan 24, 2007
#11
  • Jan 24, 2007
  • #11
It can be the fuel pump leaking oil. Check out the following link.

http://forums.stangnet.com/showthread.php?t=599562&highlight=mysterious+oil+leak
 
R

Rapid

New Member
Mar 31, 2005
297
1
0
Columbia, SC
Jan 24, 2007
#12
  • Jan 24, 2007
  • #12
This thread sounds exactly like mine. I do not have PS on my car nor AC. I will work to isolate the fuel pump from the rest of the engine. This is a new problem.
The pump has been on the car 11/2 years but I can find outlet for the oil. I can not "make" it happen and it does not happen unless I am working the engine. I'll look into the oil leak finder kit as well. I have used a spray on powder to trace leaks in the past.

Thanks!
 

tos

Founding Member
Apr 27, 2001
896
68
59
Cincinnati Ohio
Jan 25, 2007
#13
  • Jan 25, 2007
  • #13
Rapid I noticed you also posted to this thread http://forums.stangnet.com/showthread.php?t=599562&highlight=mysterious+oil+leak And said oil was coming from your dipstick. I had this problem on my first stang in 1976 and if its possibly still coming from there then thats an indication of poor or no crankcase venting. If it doesnt vent properly it will force oil out places that it normally wouldnt leak. Is the ball in your pcv valve loose when you shake it? Try popping the valve out of the valve cover but leave it attatched to the hose and run it to see what happens.
 
T

truck90278

New Member
Jun 4, 2006
382
1
0
Redondo Beach, CA
Jan 25, 2007
#14
  • Jan 25, 2007
  • #14
jcode68 said:
If you cannot visually see the leak happen whil the hood is up and you rev the engine, then it's time to get an oil leak detection kit, which is essentially a special dye and flashlight that will allow you to trace the leak. Lastly, does your car have power steering? If so, are you sure this is oil and not PS fluid? It's likely that the PS fluid would only leak while you turn the steering wheel, which builds more pressure. Would explain not being able to see a leak whil under the hood. Give us some more details and we can try to help more.
Click to expand...

you have to use a black lite with the dye to see it.
 
R

Rapid

New Member
Mar 31, 2005
297
1
0
Columbia, SC
Jan 28, 2007
#15
  • Jan 28, 2007
  • #15
tos said:
Rapid I noticed you also posted to this thread http://forums.stangnet.com/showthread.php?t=599562&highlight=mysterious+oil+leak And said oil was coming from your dipstick. I had this problem on my first stang in 1976 and if its possibly still coming from there then thats an indication of poor or no crankcase venting. If it doesnt vent properly it will force oil out places that it normally wouldnt leak. Is the ball in your pcv valve loose when you shake it? Try popping the valve out of the valve cover but leave it attatched to the hose and run it to see what happens.
Click to expand...

A proper PCV took care of the oil from the dip stick. No problems for a while and this new thing. I'll check again but the PCV was free last check.
 
T

TOM B

20+ Year Stangneter
Nov 15, 2002
872
1
16
Harrisburg Pa
Jan 28, 2007
#16
  • Jan 28, 2007
  • #16
I had this oil leak problem to, no leaks at idle but oil all over the fuel pump and oil pan and stuff, I found my FRAM PH8A oil filter was leaking at the crimped seam, I bought another Fram PH8A and that leaked at the same place, the crimped seam, so I went and got a motorcraft filter and NO more leaks. Hmmm Fram quality.
 
R

Rapid

New Member
Mar 31, 2005
297
1
0
Columbia, SC
Jan 29, 2007
#17
  • Jan 29, 2007
  • #17
TOM B said:
I had this oil leak problem to, no leaks at idle but oil all over the fuel pump and oil pan and stuff, I found my FRAM PH8A oil filter was leaking at the crimped seam, I bought another Fram PH8A and that leaked at the same place, the crimped seam, so I went and got a motorcraft filter and NO more leaks. Hmmm Fram quality.
Click to expand...

That was a concern of mine as well. I have changed filters and brands to eliminate that. No help.


Thanks
 
You must log in or register to reply here.

Similar threads

C
Bad cold starts and leaking PCV hose
  • Chiper91
  • Oct 11, 2018
  • SN95 4.6L Mustang Tech
Replies
3
Views
1K
SN95 4.6L Mustang Tech Oct 11, 2018
wmburns
B
1990 On3 Turbo Build/Review
  • BryanNux
  • Feb 18, 2019
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
24
Views
11K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Feb 21, 2019
a91what
N
SOLD Supercharged 1989 SSP Coupe $13,500 obo
  • notchlubber
  • Jul 17, 2018
  • Fox Body Mustangs For Sale (1979-93)
Replies
13
Views
13K
Fox Body Mustangs For Sale (1979-93) May 28, 2020
notchlubber
N
T
Progress Thread 1987 Mustang Gt "foxy"
  • Toole
  • Feb 21, 2016
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2 3
Replies
41
Views
9K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Feb 20, 2018
General karthief
BBK SSI Intake Warning
  • Strype
  • Jun 17, 2009
  • Fox 5.0 Mustang Tech
  • 12 13 14
Replies
268
Views
71K
Fox 5.0 Mustang Tech Sep 19, 2023
pinstrype
P
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • Classic Mustang Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?