Street Heet Trick Flow

darthcual

Member
Mar 31, 2005
985
19
18
Arlington, TX
I have some friend who used this intake say they had fitment problems and had to grind one way or the other to make it fit. Anyone else have this problem? Thanks in Advance.

PS I was leaning toward sending my stock intake to have it extrude honed but its a bit pricey.
 
I never had to grind a thing on my tfs street heat intake. I didn't have to grind anything on my tfs R intake either.

You might need to run a 3/8" spacer so the throttle cable bracket doesn't hit the valve cover. It was close but mine didn't hit but I ran a spacer anyway.
 
You're probally looking for people with problems from this, but I used it on my 95 and my friend on his 90. No problems on either install.
darthcual said:
I have some friend who used this intake say they had fitment problems and had to grind one way or the other to make it fit. Anyone else have this problem? Thanks in Advance.

PS I was leaning toward sending my stock intake to have it extrude honed but its a bit pricey.