stress cracks?

lollerskatz

New Member
Jun 15, 2006
3
0
0
Hi, i am new to stangnet and am currently in the market for a foxbody mustang. I recently saw one near Detriot and it was pretty nice, stock 5.0L, Red, vert, 77,000 miles. It was a very clean car but i noticed that there are a few stress cracks under the door panel in the frame on the driver and passenger side. these cracks are small but i am kind of concerned. i may be getting worried over nothing, but is this a big problem?, what could it lead to? and if its bad how would i go about fixing it? any advise would be greatly appreciated.

thanks, Brendan
 
Cracks are really never good on a fox body. Our frame is pretty weak to begin with so any weakening really hurts it. Subframes might be able to help which is typically one of the first mods we do to help. If you can get a pic that would help a lot but if you really want to get it, I suggest some full length subframes welded in.
Kevin
 
lollerskatz said:
Hi, i am new to stangnet and am currently in the market for a foxbody mustang. I recently saw one near Detriot and it was pretty nice, stock 5.0L, Red, vert, 77,000 miles. It was a very clean car but i noticed that there are a few stress cracks under the door panel in the frame on the driver and passenger side. these cracks are small but i am kind of concerned. i may be getting worried over nothing, but is this a big problem?, what could it lead to? and if its bad how would i go about fixing it? any advise would be greatly appreciated.

thanks, Brendan


A) Welcome to :SNSign:

B) Carfax it! You can't tell a 77k car from a well kept 177k car sometimes :nono:

C) If it has stress cracks on the frame, she's had a hard 77k, however, if it is truly 77k I say go for it :nice:
 
Welcome to :SNSign:

At the bottom of the doorjamb is a lap joint where the front and rear sections of the car are put together and welded... Is this the area we are talking about? If so, there should be a very noticable crack or seam. IF we are talking about real stress cracks, make sure the car is sitting straight. If everything checks out, weld on some subframe connectors ASAP and get a strut tower brace for that bad boy! A convertible Fox Mustang as the same bending resistance of a wet noodle.

P.S. Check out the Buying tips thread to familiarize yourself with common problems with these era cars. CLICK Good luck in your quest!
 
thanks guys, the cracks were under the wheel well twords the front kind of by the doors, (it look like someone had been doing too many burn outs) i think i'm gonna pass on this one. Thanks again for the advise.

Brendan