strut tower brace install question

[snowman23]

I recently purchased a Ford Motorsport strut tower brace for my 90GT vert. The instructions say that it may be necessary to remove the A/C line and other ignition related wiring to install. Can anyone give me any advice and/or post a pic or a link to one? I searched but couldn't find anything definitive. Thanks

 

[04sleeper]

They are really not too hard to install.

Every STB is made a little different.

Just set it down on the strut towers and see if it clears everything OK. If not move what you need to make it work.

Here is a picture of one on a friends car. Not sure of the manufacturer.

Hope this helps.

 

[ss93cobra]

You will need to remove the coil cover, coil and bracket, and perhaps the mass air sensor mounting bracket as well. The a/c line will be fine and fit between the intake manifold and and strut tower brace.

 

[mustangsally93]

and my 10 cents, do they work?

 

[04sleeper]

Read here.
http://www.maximummotorsports.com/stb.asp

 

[mustangsally93]

yea right I' m not spending 140 for that when you can get bbk on ebay for 60-80 for something I don't really works. But that me

 

[04sleeper]

yea right I' m not spending 140 for that when you can get bbk on ebay for 60-80 for something I don't really works. But that me

Ummmm. OK.

I was just showing you the benifits of having one.

 

[srothfuss]

They have to work... I don't have one and I cracked my windshield last summer from the body flex in the front of my car. Come spring time, I need a new windshield and a strut tower brace.

 

[04sleeper]

Verts are prone to flex a lot. Good investment srothfuss!