Engine Stuck Throttle Body Studs

Window · Sep 18, 2017

just bought a new edelbrock intake with matching throttle body and egr spacer and my old studs may as well be welded into the stock intake. im worried that new studs arent going to come with the throttle body/spacer so where would i buy new ones? i only see them in kits with all the gaskets etc which i dont need. i just want the studs.

mikestang63 · Sep 18, 2017

any hardware store should have them

89ripper · Sep 18, 2017

What intake did you purchase, specifically?

Window · Sep 18, 2017

edelbrock performer 3821(not the rpm) upper and lower kit with 65mm edelbrock throttle body and egr spacer. does anyone know the size of the bolt and threads? i think its 3/8" but im not sure

MFE92 · Sep 18, 2017

You can replace the studs with bolts of the correct length, or just buy some all-thread and cut to length.

General karthief · Sep 18, 2017

Check out ARP for new studs or just use bolts like was suggested, whatever you use put antisize on the threads going into the aluminum.

Window · Sep 18, 2017

from what i can find the stock size of the studs were 5/16-18 thread and 4.125 inches long. closest thing i can find on arp is a 4.25 bolt. prolly just gonna buy the kit that has the posts.

General karthief · Sep 19, 2017

Ok, so what like maybe a 1/8 inch longer arp stud? Just remember to goober it up with antiseize and don't over tighten.

Engine Stuck Throttle Body Studs

Window

Active Member

mikestang63

89ripper

Window

Active Member

MFE92

General karthief

wonder how much it would cost to ship you a pair

Window

Active Member

General karthief

wonder how much it would cost to ship you a pair

Similar threads

Engine Stuck Throttle Body Studs

Active Member

Active Member

wonder how much it would cost to ship you a pair

Active Member

wonder how much it would cost to ship you a pair

Similar threads

Privacy & Transparency

Privacy & Transparency