Studs for rockers

NewbeewithGT

New Member
Sep 30, 2007
1
0
0
I tore apart my engine as far as taking the heads of so i can replace the head gaskets. I was planning on putting roller rockers on but the problem i have now is the studs i took out of the head holding the regular rockers in are 5/16" and i can only find roller rockers for 3/8" or 7/16" stud size. Any suggestions on what to do now?

I am also thinking about going with a trick flow intake to a 75 mm throttle body, what all would i need to do to make this happen with great results?

Any info would be great! Thanks
 
Stock heads set up for pedestal mount or bolt down rockers. They use a 5/16" bolt to hold the rocker down to the head.

If you want to go stud mount you are going to have to have the heads machined. I believe that someone used to sell a pedestal to stud conversion kit but I can't recall who it was.

Personally if it was a pretty much stock engine and you wanted to put roller rockers on it I would be looking for a set of pedestal mount 1.6 ratio RRs. I have some scorpion 1.6 rrs on my 93 and they work great. I did have to clearance the baffle and do a little grinding on the strength ribs on the under side of the VC but no big deal really.
 
Comp Cams makes a set of studs for exactly that purpose, they have 5/16 threads on the bottom to go into the heads, and 3/8 studs on top for adjustable rockers.

I have over 90k miles on one set, and they work just fine.

Do make sure that the nut or base portion of stud will clear your rockers.