Stupid Brakes

rustang87

New Member
Apr 1, 2005
70
0
0
Sac
I need to beef up the front brakes bad. I have already replaced the MC, It was a crappy rebuilt one. The pedal is still mushy, going to the floor if I try. It has been properly bled a few times. The pads and rotors in the front are fine, and the fliud is full. How do you check drums? How do you adjust them? Should I replace the drum parts with oem parts? Who makes a twin piston caliper that fits under ponies for the front?
 
1) Drum shoes should be adjusted with the star adjuster at the bottom of the setup. use a flat blade screwdriver on the "star" adjuster to move the shoes out until the drum will barely fit over the shoes.

You can also drive backwards (in reverse) for 20' and then slam on the brakes and they will self adjust.

2) To get brakes that fit under ponies you will need to run a 12" rotor. To do this, you can run any PBR caliper / rotor setup off a '96-2004 Mustang. You will need to change the MC to a 94+ unit but that should be all if you can find the set at a JY.
 
Yeah, if you went the OEM route you would have to switch to a 5-lug setup which means new rims and tires.

Baer makes a 4 lug kit in a 12 Inch rotor that will clear the pony rims. It's probably just what you are looking for.